|
Who's Online
There currently are 5467 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
12. High Voltage Output & FBT (Flyback Transformer). The high voltage output circuit is used for generating pulse wave to the primary coil of the FBT (Flyback Transformer (T801)). A boosted voltage (about 27kV) appears at the secondary of the FBT and it is supplied to the anode of the CDT. And there are another output voltages such as the dynamic focus voltage. 13. H-Linearity Correction Circuit. This circuit corrects the horizontal linearity for each horizontal sync frequency. 14. Vertical Output Circuit. This circuit takes the vertical wave from the TDA4841(IC701) and performs the vertical deflection by supplying the saw-tooth wave current from the TDA8172 (IC601) to the vertical deflection yoke. 15. Dynamic Focus Output Circuit. This circuit takes H and V parabola wave from the TDA4841(IC701), and amplifies these waves to offer to the FBT (T801). 16. H & V Blanking and Brightness Control. This circuit eliminates the retrace line by supplying a negative pulse to the G1 of the CDT. 17. Image Rotation (Tilt) Circuit. This circuit corrects the tilt of the screen by supplying the image rotation signal to the tilt coil which is attached to the CDT near the deflection.
18. Static Convergence Control Circuit. This circuit corrects the convergence of the screen by supplying the convergence signal to the 4H (STC) coil which is attached to the CDT near the deflection. 19. Moire Reduction Circuit This circuit reduce interference between the periodical display pattern and the CDT's slot (or dot). The positions of every other one dot video signal beams (red, green, and blue beam) are shifted finely, thus reducing interference. 20. OSD Circuit. This circuit is used for performing the OSD (OnScreen- Display) function. When a user selects the OSD Select/Adjustment control, the adjustment status displays on the screen. 21. Video Pre-Amp Circuit. This circuit amplifies the analog video signal from 00.7V to 0-4V. This circuit is operated by taking the clamp, R, G, B drives, and contrast signals from the Micom (IC401). 22. Video Output Amp Circuit. This circuit amplifies the video signal which comes from the video pre-amp circuit and amplified video signal is applied to the CDT cathode.
- 13 -
|
|
|
> |
|